6.1) Left-hand fitting - Fix the operator to the foundation base and secure it by means of nuts M12 (fig.4 ref.1). The door of the box must face towards the inside of the property. - The upper surface of the operator is slightly tilted so as to prevent any rain water from being trapped there. Therefore use a side surface to check correct positioning by means of a level (fig.2). - The installation of the MOOVI PRM antishearing Kit (optional) is easier when carried out before fitting the boom to the operator. Make reference to Fig.18 and paragraph 6.4 for correct fitting of the MOOVI PRM Kit, then proceed to fit the boom. - Fit the boom in its opening position (vertical) as indicated in fig.3, ref.7. The operator balancing is pre-calibrated for the nominal boom in the opening position (balancing spring stretched). - Position the cover closing element (fig.3 ref.10) on the boom, as indicated in fig. 3. After positioning, drill part 10 and boom using a 2 mm bit. Insert the screw supplied. - Fix the boom using the bracket (fig.3 ref.4) and the screws and washers supplied as standard, then fix the protection cover (fig.3 ref.8) and finally the screw cover (fig.3 ref.9). Close the protection cover by making the closing element slide over the boom (fig.3 ref.10). WARNING! The boom must be positioned so as to have the double contour facing down (fig.3 ref.11). - Balance the boom as described in relevant paragraph 7. 6.2) Right-hand fitting Some internal members need to be moved, with reference to fig. 4 and the following procedure: A) Fix the box to the foundation base and lock it in position using M12 nuts. B) Ensure that the balancing spring is in the opening position (stretched spring - fig.5). C) Completely slacken the spring stretcher (fig.4/ref. 2) until the screw (fig. 4/ref.3) anchoring it to the bottom of the box can be removed. D) Remove the bar locking bracket (fig.4/ref.4) and slacken the screw (fig. 4/ref.5) by means of a CH19 socket spanner until the lever can be rota-ted (fig.4/ref.6). E) Rotate the lever (fig.4/ref.6) by 180° and fasten it into the correct posi

MOOVI 50

metal arm , openinig time 8 SEC ,IP24